:	May 4, 2004

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the fender mouldings.

.

Remove the 14 front bumper cover screws.

.

:   Some fluid spillage is inevitable during this operation. Remove the front bumper cover.   Disconnect the 2 electrical connectors.   Release the head lamp washer jet hose from the washer pump.   Allow the fluid to drain into a container.

.

:   Do not disassemble further if the component is removed for access only. Remove the washer jets.

.

Remove the parking aid sensors.   Disconnect the electrical connector.   Release the 2 clips.   Repeat the above procedure for the remaining 3 sensors.

.

Remove the parking aid sensor wiring harness.   Remove the 9 securing straps.

.

Remove the headlamp washer jet hose.   Release from the 5 clips.

.

Install the headlamp washer jet hose.   Secure in the 5 clips.

.

Install the parking aid sensor wiring harness.   Install the securing straps.

.

Install the parking aid sensors.   Connect the parking aid electrical connectors.

.

Install the washer jets.

.

Install the front bumper cover.   Connect the parking aid sensor wiring harness electrical connectors.   Connect the head lamp washer jet hose to the washer pump.   Install the screws.

.

Install the fender mouldings.